A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.
Drain tile that isn't sloped correctly is one of the most common installation failures we see when repairing someone else's prior work — water simply pools instead of flowing to the basin. We verify slope with a level, not by eye.
Every technician is trained specifically on interior drain tile layout, slope, and tie-in to the sump system.
Interior drainage installs are scheduled locally, without routing through a national call center that adds weeks to the timeline.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Drain tile that isn't sloped correctly simply won't move water — we verify slope with a level during installation, not just by eye.
Every Florence, SC Interior Drainage System job starts with an inspection, not a generic package — here's what that typically includes.
We route the full perimeter or targeted sections depending on where moisture is actually entering, based on the inspection.
Every interior drain system needs a sump basin as its endpoint — we size the basin and pump to match the drain tile's expected inflow.
For finished basements where cutting the slab isn't practical, a baseboard channel system captures wall seepage without disturbing existing flooring.
The cove joint where wall meets floor is sealed and tied directly into the drain system so water is captured right at the entry point.
Existing drain tile that's clogged with silt or has failed slope can often be cleaned or repaired rather than fully replaced.
This helps us bring the right materials and estimate linear footage before the visit.
A technician checks where water is entering, measures the perimeter, and identifies the best sump basin location for discharge.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
We test the system with water flow before finishing to confirm proper slope and basin performance.
"Water was coming in along one wall every heavy rain. They installed targeted drain tile just on that section instead of charging us for the whole perimeter."
— Florence Homeowner
"Cove joint had been the source of our leak for years and nobody had addressed it until now."
— Florence Customer
"They tested the system with a hose before calling it done, which gave us confidence it would actually work in a real storm."
— Florence Homeowner
"Sump basin placement was smarter than what a previous contractor had proposed — shorter discharge run, less noise."
— Florence Customer
Full perimeter systems make sense when multiple walls show signs of intrusion or as preventive coverage.
Drain tile requires cutting the slab; a baseboard channel is a lower-disruption alternative that captures wall seepage without floor demolition.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
Basin size is based on expected water inflow from the drain tile's linear footage and your Florence, SC area's typical rainfall intensity.
Cutting the slab does involve some disruption, but we work in sections and clean up debris as we go.
We give you a realistic timeline in the written quote based on your specific basement layout.
Not sure if your basement needs full perimeter drain tile or a targeted fix? Call +1-866-476-1348 and we'll walk through it.
Zip codes we serve in Florence, SC: 29505 29506 29501 29502 29503 29504
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
